OPTICOTE SUPERDUR 80

Technical Data

Health & Safety

Gloves, overalls and barrier cream should be used when working with Opticote Superdur 80. For full details please refer to the appropriate Health and Safety Data Sheet.

Health & Safety Data Sheet

Surface Preparation

All surface contaminants should be removed and the surface abraded by mechanical means to remove surface laitance. On a high strength power floated concrete floor it is important to provide a mechanical key. Any greasy stains or deposits must be removed prior to application.

A primer may be required depending on the type and density of the concrete – refer to Optus Resin.

New unmodified OPC concrete should be allowed to cure for between 30 and 60 days depending on the residual moisture content of the concrete unless using approved moisture barrier.

Application

Pack A - Hardener | Pack B - Resin

Thoroughly mix the Pigmented B component prior to use using a drill and paddle for one minute or until consistent colour is achieved. Mix components A and B for 60
seconds. Use a squeegee and back roll with short haired 3/8” roller for best results. On dense concrete roll vigorously into the surface for maximum penetration. Multiple coats should be applied without delay following initial cure (varies with grade of product used). Mechanical abrasion will be necessary if there is a delay in application.

For added slip resistance white Aluminum oxide can be scattered over the surface and back-rolled to coat with the Opticote Superdur product.

Note: Hand Application Only

Download TDS

Cleaning

Acetone should be used for cleaning tools, etc.

VOC Compliant (USA)
Abrasion resistant
Chemical resistant
Hygienic
Easy to apply, using brush or roller
Fast cure: reduced downtime
Excellent UV stability: colours stay bright
Cures from low temperature: excellent for chilled storage
High tyre stain resistance—dirt shedding: lines stay visible
Good colour range: white, yellow, red, green, blue and clear - others on request

Opticote Superdur 80 is ideally suited to high stress situations where durability (especially onto concrete) and colour stability are particularly important. Its impressive chemical resistance, along with the ability to be applied and maintained sub-zero, the following will all benefit:

Food Processing Areas
Chemical Plants
Chilled Distribution
Manufacturing Plants
24-hour Distribution Centers

In addition to internal applications Opticote Superdur 80 can be used externally in a multitude of situations and can be combined with high friction grit to achieve a durable anti-slip surface.